H3C S3610-28P Operation Manual page 1498

Operation Manual – RRPP
H3C S3610&S5510 Series Ethernet Switches
Figure 1-7 Single ring networking diagram
II. Configuration considerations
First, determine the node mode of a device in an RRPP ring, and then perform the
following configurations on a per-device basis:
Create an RRPP domain.
Specify the control VLAN for the RRPP domain.
Specify the node mode of a device on the primary ring and the ports accessing the
RRPP ring on the device.
Enable the RRPP ring.
Enable RRPP
III. Configuration procedure
1) Perform the following configuration on Device A:
<Device A> system-view
[Device A] rrpp domain 1
[Device A-rrpp-domain1] control-vlan 4092
[Device A-rrpp-domain1] ring 1 node-mode master primary-port ethernet 1/0/1
secondary-port ethernet 1/0/2 level 0
[Device A-rrpp-domain1] ring 1 enable
[Device A-rrpp-domain1] quit
[Device A] rrpp enable
2) Perform the following configuration on Device B:
<Device B> system-view
[Device B] rrpp domain 1
[Device B-rrpp-domain1] control-vlan 4092
[Device B-rrpp-domain1] ring 1 node-mode transit primary-port ethernet 1/0/1
secondary-port ethernet 1/0/2 level 0
1-19
Chapter 1 RRPP Configuration