Configuring Master Node; Configuration Procedure - H3C S3610-28P Operation Manual

Operation Manual – RRPP
H3C S3610&S5510 Series Ethernet Switches
Note:
If you need to transparently transmit RRPP packets on a device without enabling
RRPP, you should ensure only the two ports accessing an RRPP ring permits the
packets of the control VLAN. Otherwise, the packets from other VLANs may go into
the control VLAN in transparent transmission mode and strike the RRPP ring.
Do not set the default VLAN ID of a port accessing an RRPP ring to primary control
VLAN ID or secondary control VLAN ID (the latter is equal to the former plus 1),
avoiding the influence on the proper receiving/sending of RRPP packets.

1.3 Configuring Master Node

1.3.1 Configuration Procedure

Follow these steps to configure master node:
Enter system view
Create an RRPP domain
and enter its view
Specify control VLAN for
the RRPP domain
Specify the current device
as the master node of the
ring, and specify the
primary port and the
secondary port
Configure the timer for the
RRPP domain
Enable the RRPP ring
Return to system view
Enable RRPP
To do...
system-view
rrpp domain domain-id
control-vlan vlan-id
ring ring-id node-mode
master [ primary-port
interface-type
interface-number ]
[ secondary-port
interface-type
interface-number ] level
level-value
timer hello-timer
hello-value fail-timer
fail-value
ring ring-id enable
quit
rrpp enable
Use the command...
1-11
Chapter 1 RRPP Configuration
Remarks
—
Required
Required
Required
Optional
By default, the Hello timer
value is 1 second and the
Fail timer value is 3
seconds.
Required
By default, the RRPP ring
is disabled.
—
Required
By default, RRPP is
disabled.