Mac Address Table; Static Mac; Figure 4.51 L2 Switching > Loopback Detection > Port Settings - Advantech EKI-7710E-2C User Manual

The following table describes the items in the previous figure.
Item
State
Interval
Recover Time
Apply
The ensuing table for Loopback Detection Global Information settings are infor-
mational only: State, Interval and Recover Time.
4.5.13.2 Port Settings
The Port Settings page allows you to select ports that are detected by the loopback
detection function and configure their status (enabled or disabled).
To access this page, click L2 Switching > Loopback Detection > Port Settings.
Figure 4.51 L2 Switching > Loopback Detection > Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Enabled
Apply
The ensuing table for Loopback Detection Port Information settings are informa-
tional only: Port, Enable State and Loop Status.
4.6

MAC Address Table

The MAC Address Table provides access to the Static MAC Settings, MAC Aging
Time, and Dynamic Forwarding.
4.6.1

Static MAC

The Static MAC page allows you to configure the address for forwarding of packets,
the VLAN ID of the listed MAC address and the designated Port.
EKI-7710 Series User Manual
Description
Select Enabled or Disabled to setup the loopback mode.
Enter the variable in seconds (1 to 32767) to set the interval at which
frames are transmitted.
Enter the variable in seconds (60 to 1000000) to define the delay
before recovery.
Click Apply to save the values and update the screen.
Description
Enter the port to define the local loopback detection setting.
Select Enabled or Disabled to setup the Loopback Detection func-
tion.
Click Apply to save the values and update the screen.
69