Configuring A Plot Function; If You Are Plotting To An Hpgl/2 Compatible Printer - Agilent Technologies 8753ET User Manual

Configuring a Plot Function

All copy configuration settings are stored in non-volatile memory. Therefore, they are not affected if you
press or switch off the analyzer power.
Preset
Peripheral Interface
Parallel
GPIB
Serial
1. Connect the peripheral to the interface port using the recommended cable from the following list.
Figure 4-3 Peripheral Connections to the Analyzer

If You Are Plotting to an HPGL/2 Compatible Printer

2. Press
Local SET ADDRESSES
PRT appears.
Information regarding a printer compatibility guide (an up-to-date list of printers that are compatible with
the network analyzer) is available in
3. Configure the analyzer for one of the following printer interfaces:
• Choose
PRNTR PORT GPIB
function as follows:
a. Enter the GPIB address of the printer (default is 01), followed by
b. Press
Local
the GPIB bus.
c. Press
Local
GPIB bus.
• Choose
PARALLEL
print function as follows:
Recommended Cables
92284A
10833A/33B/33D
24542G
PLTR PORT
"Printing or Plotting Your Measurement Results" on page
if your printer has an GPIB interface, and then configure the print
and
SYSTEM CONTROLLER
and
USE PASS CONTROL
if your printer has a parallel (Centronics) interface, and then configure the
Printing, Plotting, and Saving Measurement Results
Configuring a Plot Function
and then press
PLTR TYPE [ ]
x1
if there is no external controller connected to
if there is an external controller connected to the
until HPGL
4-3.
.
4- 9