Printing, Plotting, and Saving Measurement Results
Configuring a Plot Function
Configuring a Plot Function
All copy configuration settings are stored in non-volatile memory. Therefore, they are not
affected if you press
Peripheral Interface
Parallel
GPIB
Serial
1. Connect the peripheral to the interface port using the recommended cable from the
following list.
Figure 4-3 Peripheral Connections to the Analyzer
If You Are Plotting to an HPGL/2 Compatible Printer
2. Press
SET ADDRESSES
Local
HPGL PRT appears.
4-10
or switch off the analyzer power.
Preset
Recommended Cables
92284A
10833A/33B/33D
24542G
PLTR PORT
and then press
PLTR TYPE [ ]
until