Agilent Technologies 8753ET User Manual page 147

Figure 2-7 Down Converter Port Connections
• In an up converter measurement where the
the setup diagram indicates that the analyzer's source frequency is labeled IF, connecting to the mixer IF
port, and the analyzer's receiver frequency is labeled RF, connecting to the mixer RF port.
Because the RF frequency can be greater or less than the set LO frequency in this type of measurement,
you can select either
Figure 2-8 Up Converter Port Connections
UP CONVERTER
or
RF > LO RF < LO
Measurement Considerations
softkey is selected, the notation on
.
Making Mixer Measurements
2- 9