Agilent Technologies 8753ET User Manual page 229

3. Select one of the following printer interfaces:
• Choose
PRNTR PORT GPIB
function as follows:
a. Enter the GPIB address of the printer, followed by
b. Press
Local
the GPIB bus.
c. Press
Local
GPIB bus.
• Choose
PARALLEL
print function as follows:
Press and then select the parallel port interface function by pressing
Local
the correct function appears.
❏ If you choose
(printers or plotters).
❏ If you choose
cannot be used for printing or plotting.
• Choose
SERIAL
function as follows:
a. Press
PRINTER BAUD RATE
b. To select the transmission control method that is compatible with your printer, press
XMIT CNTRL
❏ If you choose
exchange by transmitting control characters to the network analyzer.
❏ If you choose
exchange by setting the electrical voltage on one line of the RS-232 serial cable.
NOTE Because the
or software, it is the fastest transmission control method.
if your printer has a GPIB interface, and then configure the print
and
SYSTEM CONTROLLER
and
USE PASS CONTROL
if your printer has a parallel (Centronics) interface, and then configure the
PARALLEL [COPY]
PARALLEL [GPIO] , the parallel port is dedicated for general purpose I/O, and
if your printer has a serial (RS-232) interface, and then configure the print
and enter the printer's baud rate, followed by
(transmit control - handshaking protocol) until the correct method appears.
, the handshake method allows the printer to control the data
Xon-Xoff
, the handshake method allows the printer to control the data
DTR-DSR
handshake takes place in the hardware rather than the firmware
DTR-DSR
Printing, Plotting, and Saving Measurement Results
.
x1
if there is no external controller connected to
if there is an external controller connected to the
, the parallel port is dedicated for normal copy device use
Configuring a Print Function
PARALLEL
.
x1
until
4- 5