Configuring A Plot Function; If You Are Plotting To An Hpgl/2 Compatible Printer - Agilent Technologies 8753ET User Manual

Printing, Plotting, and Saving Measurement Results
Configuring a Plot Function
Configuring a Plot Function
All copy configuration settings are stored in non-volatile memory. Therefore, they are not
affected if you press
Peripheral Interface
Parallel
GPIB
Serial
1. Connect the peripheral to the interface port using the recommended cable from the
following list.
Figure 4-3 Peripheral Connections to the Analyzer

If You Are Plotting to an HPGL/2 Compatible Printer

2. Press
SET ADDRESSES
Local
until the correct printer choice appears:
ThinkJet (QuietJet)
DeskJet (This supports most current models such as DeskJet 890C, DeskJet 895C, or
DeskJet 1600C. See also DJ 540 selection.)
LaserJet (only LaserJet models III, 4, 5, and 6)
PaintJet
Epson-P2 (printers that conform to the ESC/P2 printer control language, such as
Epson LQ-570)
DJ 540 (This can be used for printers that do not support 100 dots per inch (dpi) but
do support 300 dpi such as the HP DeskJet 540 or 850C.)
Information regarding a printer compatibility guide (an up-to-date list of printers that
are compatible with the network analyzer) is available in
4-10
or switch off the analyzer power.
Preset
Recommended Cables
92284A
10833A/33B/33D
24542G
PRINTER PORT
and then press
PRNTR TYPE [ }
"Printing or Plotting Your