Agilent Technologies 8753ET User Manual page 117

the key and scroll through the command list backwards.
• If you use the
actually performed when the cursor points to them. This feature allows the sequence to be tested
one command at a time.
4. To delete the selected command, press:
(backspace key)
5. Press
Seq DONE SEQ MODIFY
Inserting a Command
1. To enter the creation/editing mode, press:
NEW SEQ/MODIFY SEQ
Seq
2. To select the particular test sequence you wish to modify (sequence 1 in this example), press:
SEQUENCE 1 SEQ1
3. To insert a command, move the cursor to the line immediately above the line where you want to insert a
new command, by pressing:
or
• If you use the
actually performed when the cursor points to them. This feature allows the sequence to be tested
one command at a time.
• If you wish to scroll through the sequence without executing each line as you do so, you can press
the key and scroll through the command list backwards.
4. To enter the new command, press the corresponding analyzer front panel keys. For example, if you want
to activate the averaging function, press:
Avg AVERAGING ON
5. Press
DONE SEQ MODIFY
Seq
Modifying a Command
1. To enter the creation/editing mode, press:
Preset Seq NEW SEQ/MODIFY SEQ
2. To select the particular test sequence you wish to modify, (sequence 1 in this example), press:
SEQUENCE 1 SEQ1
The following list is the commands entered in
longer sequences, only a portion of the list can appear on the screen at one time.
Start of Sequence
RECALL PRST STATE
Trans: FWD S21 (B/R)
LOG MAG
key to move the cursor through the list of commands, the commands are
to exit the modify (edit) mode.
key to move the cursor through the list of commands, the commands are
to exit the modify (edit) mode.
"Creating a Sequence" on page
Making Measurements
Using Test Sequencing
1-100. Notice that for
1- 103