If You Are Plotting To An Hpgl Compatible Printer - Agilent Technologies 8753ET User Manual

If You Are Plotting to an HPGL Compatible Printer

1. Configure and define the plot, as explained in
Plot Function" on page
2. Press
Copy PLOT
NOTE
Use test sequencing to automatically plot all four S-parameters.
1. Set all measurement parameters.
2. Perform a full 2-port calibration.
3. Enter the test sequence:
Seq
Meas
Copy
Meas
Copy
Meas
Copy
Meas
Copy
Seq
4. Run the test sequence by pressing:
Seq
Plotting Multiple Measurements Per Page Using a Pen Plotter
"Configuring a Plot Function" on page 4-9
4-13.
PLOTTER FORM FEED
NEW SEQ/MODIFY SEQ
Refl: FWD S11 (A/R)
SEL QUAD [ ]
Trans: FWD S21 (B/R)
SEL QUAD [ ]
Refl: REV S22 (B/R)
SEL QUAD [ ]
Trans: REV S12 (B/R)
SEL QUAD [ ]
DONE SEQ MODIFY
DO SEQUENCE
Printing, Plotting, and Saving Measurement Results
to print the data the printer has received.
SEQUENCE 1 SEQ1
SELECT DISK LEFT UPPER PLOT
LEFT LOWER PLOT
RIGHT UPPER PLOT
RIGHT LOWER PLOT
SEQUENCE 1 SEQ1
and "Defining a
4- 19