Agilent Technologies 8753ET User Manual page 99

Figure 1-67 Connections for an Example Ripple Test Measurement
2. Press and choose the measurement settings. For this example, the measurement settings are
Preset
as follows:
•
Meas Trans: FWD S21 (B/R)
•
Center 1.8
•
Span 3.4 G/n
•
AUTO SCALE
Scale Ref
You may also want to select settings for the number of data points, power, averaging, and IF bandwidth.
3. Substitute a thru for the device and perform a response calibration by pressing:
CALIBRATE MENU
Cal
4. Reconnect your test device.
5. To better view the measurement trace, press
or on ET models:
G/n
RESPONSE
Scale Ref
Using Ripple Limits to Test a Device
TRANSMISSN
THRU
AUTO SCALE
Making Measurements
. Refer to Figure 1-68.
1- 85