Assigning Static Mvr Multicast Groups To Interfaces - Edge-Core ES3528MV2 Management Manual

| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv4
A
SSIGNING
S MVR
TATIC
M G
ULTICAST ROUPS
I
TO NTERFACES
W I
EB NTERFACE
To configure interface settings for MVR:
Click Multicast, MVR.
1.
Select Configure Interface from the Step list.
2.
Select Configure Port or Configure Trunk from the Action list.
3.
Select an MVR domain.
4.
Set each port that will participate in the MVR protocol as a source port
5.
or receiver port, and optionally enable Immediate Leave on any
receiver port to which only one subscriber is attached.
Click Apply.
6.
Figure 393: Configuring Interface Settings for MVR
Use the Multicast > MVR (Configure Static Group Member) page to
statically bind multicast groups to a port which will receive long-term
multicast streams associated with a stable set of hosts.
CLI R
EFERENCES
◆ "mvr vlan group" on page 1268
C U
OMMAND SAGE
Multicast groups can be statically assigned to a receiver port using this
◆
configuration page.
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
◆
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
Only IGMP version 2 or 3 hosts can issue multicast join or leave
◆
messages. If MVR must be configured for an IGMP version 1 host, the
multicast groups must be statically assigned.
– 652 –