Configuring Static Dns Host To Address Entries; Figure 301: Showing The List Of Name Servers For Dns; Figure 302: Configuring Static Entries In The Dns Table - Edge-Core ECS4210-12P Web Management Manual

Figure 301: Showing the List of Name Servers for DNS

Configuring
Use the IP Service > DNS - Static Host Table (Add) page to manually configure static
Static DNS Host to entries in the DNS table that are used to map domain names to IP addresses.
Address Entries
Command Usage
◆
Parameters
These parameters are displayed:
◆
◆
Web Interface
To configure static entries in the DNS table:
1.
2.
3.
4.

Figure 302: Configuring Static Entries in the DNS Table

Static entries may be used for local devices connected directly to the attached
network, or for commonly used resources located elsewhere on the network.
Host Name – Name of a host device that is mapped to one or more IP
addresses. (Range: 1-127 characters)
IP Address – IPv4 or IPv6 address(es) associated with a host name.
Click IP Service, DNS, Static Host Table.
Select Add from the Action list.
Enter a host name and the corresponding address.
Click Apply.
– 457 –
Chapter 15
| IP Services
Domain Name Service