Ethernet Interface (Rj-45 Ethernet); Ethernet Interface (Fiber, Sfp) - Edge-Core ECIS4500 Series Quick Installation Manual

Ethernet Interface (RJ-45 Ethernet)

The switch provides two types of Ethernet interfaces: electrical (RJ-45) and optical (SFP) interfaces.
Connecting the Ethernet interface via RJ-45:
● To connect the switch to a PC, use straight-through or cross-over Ethernet cables,
● To connect the switch to an Ethernet device, use UTP (Unshielded Twisted Pair) or STP (Shielded
Twisted Pair) Ethernet cables.
The pin assignment of RJ-45 connector is shown in the following figure and table.

Ethernet Interface (Fiber, SFP)

For both 100/1000 Mbps fiber speed connections, the SFP slots are available. The SFP slot accepts the
fiber transceivers that typically have an LC connector.
The fiber transceivers have options of multimode, single mode, long-haul or special-application
transceivers.
DANGER: Never attempt to view optical connectors that might be emitting laser energy.
Do not power up the laser product without connecting the laser to the optical fiber and
putting the dust cover in position, as laser outputs will emit infrared laser light at this point.
ECIS4500-6T2F/6T4F/8T2F
Pin Assignment
1,2 T/Rx+,T/Rx-
3,6 T/Rx+,T/Rx-
4,5 T/Rx+,T/Rx-
7,8 T/Rx+,T/Rx-
ECIS4500-8P2T4F/8P4F/4P2T2F/4P4T
Pin Assignment
1,2 T/Rx+,T/Rx-
3,6 T/Rx+,T/Rx-
4,5 T/Rx+,T/Rx-
7,8 T/Rx+,T/Rx-
8
ECIS4500 Quick Installation Guide
PoE Assignment
Positive V
Port
Negative V
Port
X
X