Digi TransPort WR31 User Manual page 548

Configure legacy protocols
Entity Instance
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
tpad n
Digi TransPort WR Routers User Guide
Parameter Values
samecall 2
delimchar 32-127
ftime 0-20000
trig_str text
IPaddr IP address
iphdr 0=Off
1=On
2=8583 Ascii 4 byte
termid text
dotermid 1=enabled, 0=disabled
tid text
merchnum text
useconstr 1=enabled, 0=disabled
constr text
pollchars text
domsgnb 1=enabled, 0=disabled
disdir 1=enabled, 0=disabled
bdir 1=enabled, 0=disabled
uaarc 0-99
clear_dirtime 0-60000
trandel 0-5000
teretran 1=enabled, 0=disabled
delstx 1=enabled, 0=disabled
no_enq 1=enabled, 0=disabled
Configure TPAD parameters
Equivalent web parameter
Allow concurrent transactions.
Use ASCII character x as the
delimiter character.
Forward mode time x milliseconds.
Create an event when reply from
X.25 host matches.
Connect to remote IP address.
IP length header.
Use Terminal ID (TID).
Replace TID provided by
connected terminal with
configured TID.
Use TID xxxxxxxxx with incoming
APACS 50 polling calls.
Use merchant Number.
Use Connect String.
Use Connect String.
The polling character set is c.
Enable Message Numbering
Disable Direct Mode.
Boot to Direct Mode.
Use response code n in unable to
authorise message.
Clearing time n milliseconds.
Delay transmitting the APACS 30
string for x milliseconds after
connecting to X.25 host.
Retransmit APACS 30 string if error
detected.
STX/ETX removal.
Do not transmit ENQ characters.
548