Digi TransPort WR31 User Manual page 589

Configure legacy protocols
ICLR command: Invitation To CLR
The ICLR command invites the remote X.25 service to CLR the current X.25 session.
INT command: Send interrupt packet
INT causes PAD to transmit an interrupt packet. These packets flow outside normal buffering/flow
control constraints interrupt the current activity.
LOG command: logoff and disconnect
LOG terminates an X.25 session. It causes the PAD to clear any active X.25 calls, disconnect, and
return to AT command mode.
PAR? command: List Local X.3 parameters
PAR? lists the local X.3 parameters for the current session.
PROF command: Load/Save PAD profile
The PROF command stores or retrieves a pre-defined set of X.3 PAD parameters, called a PAD
profile. The information is stored in system file called X3PROF. There are 4 pre-defined profiles,
numbered 50, 51, 90, and 91. Additionally, you can create 4 user PAD profiles, numbered 1 to 4.
Profile 50 is automatically loaded when a PAD is first activated. To load one of the other pre-defined
profiles, use the PROF command, followed by the required profile number. For example:
PROF 90
To create a user PAD profile, use the SET command to configure the various PAD parameters to suit
your application, then use the PROF command in the format:
PROF &nn
where nn is the number of the User PAD profile to store, such as 03. Alternatively, you can use the
web interface to edit the parameters directly (Configuration > Network > Legacy Protocols > X.25
> PADs n-n > PAD n > PAD Settings).
Digi TransPort WR Routers User Guide
Configure X.25 parameters
589