Digi TransPort WR31 User Manual page 832

Device administration
scan/scanr command: Scan the file system
The scan command performs a diagnostic check on the file system and reports any errors. For
example:
scan
Please wait...
direct ....ok
sbios ....ok
mirror ....ok
image ....ok, data ok
sregs.dat ....ok
x3prof ....ok
CAcert.cer ....ok
The scanning process may take several seconds so you should not enter any other commands until
the results are listed.
The scanr command works in a similar fashion, except that it returns ERROR if any file is in error.
This is useful when using scripts that can look for the ERROR failure result.
type command: Display a text file
The type command displays the contents of a text file. The format is:
type <filename>
For example:
type config.da0
[CFG]
config last_saved "12:04:45, 31 Jan 2011"
config last_saved_changes "1"
config last_saved_user "ASY 0"
eth 0 descr "LAN 0"
eth 0 IPaddr "10.1.51.3"
eth 0 mask "255.255.0.0"
eth 0 bridge ON
eth 1 descr "LAN 1"
eth 2 descr "LAN 2"
eth 3 descr "LAN 3"
eth 4 descr "ATM PVC 0"
xmodem command: Initiate an XMODEM file upload
The xmodem command initiates an XMODEM file upload from the port at which the command is
entered. The format is:
xmodem <filename>
<filename>
The name under which the file will be saved when the upload is complete.
After the xmodem command is entered, the router waits for your terminal program to start
transmitting the file. When the upload is complete and the file has been saved, the router responds
with the OK result code.
To initiate a remote XMODEM upload, establish a Telnet session over ISDN, and then issue the
xmodem command from the remote terminal.
Digi TransPort WR Routers User Guide
Manage files
821