Configure network interfaces
PPP QoS parameters
The parameters on this page control the Quality of Service management facility. Each PPP instance
has an associated QoS instance, where PPP 0 maps to QoS 0, PPP 1 maps to QoS 1, and so on.
These QoS instances include ten QoS queues into which packets may be placed when using QoS.
Each of these queues must be assigned a queue profile from the twelve available.
To configure the PPP QoS parameters, set the following values:
Enable QoS on this interface
When enabled, displays the following QoS configuration parameters:-
Link speed n Kbps: The value in this text entry box should be set to the maximum data rate
•
that this PPP link is capable of sustaining. The router uses this setting when calculating
whether the data rate from a queue exceeds its minimum Kbps setting, as determined by the
profile assigned to it and send at a higher rate, up to the maximum Kbps setting.
Queue n: Below this column heading, is a list of ten queue instances. Each instance is
•
associated with the profile and priority on the same row.
Profile n: This column contains the profile to be associated with the queue. There are twelve
•
available, 0-11, selected from the drop-down list boxes.
Priority: Assigns a priority to the selected queue. Available priorities are: Very High, High,
•
Medium, Low, and Very Low.
Digi TransPort WR Routers User Guide
Configure Advanced interfaces settings: External modems and PPP
329