Digi TransPort WR31 User Manual page 507

Configure Quality of Service (QoS)
Examples
To display a DSCP mapping from the command line, type the following:
▪
dscp <code> ?
Where <code> is a valid DSCP code from 0 to 63, or 64 (see note below).
To change the value of a parameter, use the following command:
▪
dscp <code> q <value>
Where <code> is a valid DSCP code and <value> is from 0 to 9.
To set the default mapping value, enter the command:
▪
dscp 64 q <value>
Where <value> is the default queue number required and has a value from 0 to 9.
Note DSCP code 64 is not actually a valid code, but is employed here to set up the default priority.
Digi TransPort WR Routers User Guide
DSCP Mappings parameters
507