Digi TransPort WR11 EVDO Quick Start Manual

1

Package Contents

a TransPort WR11
c Power Supply
If any item is missing or damaged, please contact your supplier. Also, make a record of any damage that may have occurred during
shipping and report it to the supplier.
Depending on model and configuration, the package will also contain additional cables/antennas as appropriate.
2

Connect Antenna and Power Supply

A
Connect Antenna: Connect the cellular antenna to the
connector (SMA Female) on the unit.

Mounting Tips!

The Digi TransPort WR11 should be positioned on a flat, level surface. The unit is designed for indoor use and should be mounted in a location
with adequate ventilation. Also, do not expose the unit to extreme heat or cold, strong magnetic fields, or liquids.
f
3
Configure the Unit
To use your Digi TransPort WR11, you must first activate the device with your carrier(Verizon or Sprint).
This process involves supplying them with the MEID number from your device which is printed
on the label.
Connect an Ethernet Cable:
A
ethernet port on the unit and the other end an ethernet port on a PC.
Ensure that the DHCP client is enabled on the PC.
Note: The ethernet cable required for the connection is customer supplied.
The cable is not included in the package.
Antenna
b
d
Connect one end of the cable to the
Quick Start Guide
B Connect Power Supply:
supply to the power connector on the unit, and plug the other end into
a wall outlet.
Insert power supply end fully and
rotate clockwise to engage
and lock.
TransPort WR11
EVDO Models
90001388_C
Connect the plug end of the 5 volt power