Digi TransPort WR31 User Manual page 419

Configure Virtual Private Networking (VPN)
Related CLI commands
Entity Instance Parameter
eroute n mode
eroute n ahauth
eroute n ipcompalg
eroute n oosdelsa
eroute n ifvrrpmaster
eroute n nosaoos
eroute n nosadeactcnt
eroute n check_apnbu
eroute n apnbu
eroute n ifent
eroute n ifadd
eroute n inhibitno
eroute n requireno
eroute n usesecip
eroute n ipent
eroute n ipadd
eroute n intunnel
eroute n natkaint
eroute n proto
Digi TransPort WR Routers User Guide
Values Equivalent web parameter
tunnel, transport IPsec Mode.
off, md5, sha1 Use a AH authentication on this tunnel.
off, deflate Use c compression on this tunnel.
on, off Delete SAs when this tunnel is down.
on, off Delete SAs when router is not a VRRP master.
on, off Go out of service if automatic establishment
fails.
Integer Go out of service after n consecutive auto-
negotiation failures.
on, off This tunnel can only use apn.
0=Main APN This tunnel can only use apn.
1=Backup APN
blank, ETH, PPP Link tunnel with interface with x,y.
x=Interface type
Integer Link tunnel with interface with x,y.
y=Interface number
Comma- Inhibit this IPsec tunnel when IPsec tunnels n
separated list of are up.
Integers
Integer Inhibit this IPsec tunnel unless IPsec tunnel n is
up.
on, off IKE negotiation source IP address is taken from
the Secondary IP Address.
blank, ETH, PPP IKE negotiation source IP address is taken from
the Interface x,y.
x=Interface type
Integer IKE negotiation source IP address is taken from
the Interface x,y.
y=Interface number
on, off Tunnel this IPsec tunnel inside another IPsec
tunnel.
Integer NAT-Traversal Keepalive timer s seconds.
off, tcp, udp, gre Allow protocol IP protocol(s) in this tunnel.
IPsec parameters
419