Configure security settings
Related CLI commands
Entity
Instance
cfilter
n
cmd
n
cmd
n
Enable command filtering
To enable command filtering from the command line for any particular instance of the command
interpreter, use the following command:
cmd <n> cfilton 1
The default action is to respond with the OK response. If the response needed is ERROR, use the
parameter:
cmd <n> cfilterr 1
Where n is the instance number.
Note
Enclose any blank characters by double quotation marks. When substituting a command,
upper case characters are considered the same as the corresponding lowercase characters.
Digi TransPort WR Routers User Guide
Parameter
Values
cmd
Valid command line
command
cfilton
0, 1
0=Off
1=On
cfilterr
0, 1
0=Off-OK
1=On-ERROR
Command filters
Equivalent web parameter
Command
n/a
n/a
727