Digi TransPort WR31 User Manual page 318

Configure network interfaces
Related CLI commands
Entity Instance Parameter
ppp n metric
ppp n settledly
ppp n aodion
ppp n autoassert
ppp n immoos
ppp n rdoosdly
ppp n aodi_dly
ppp n aodi_dly2
ppp n pwr_dly
ppp n minup
ppp n multi
ppp n netip
ppp n block_dns
ppp n rbcast
Digi TransPort WR Routers User Guide
Configure Advanced interfaces settings: External modems and PPP
Values
0-255
0-200
0, 1, 2
0=disabled
1=enabled
2=On and return
to service
immediately
0, 1, 2
0=no autoassert
1=autoassert with
route up delay
2=autoassert with
no route up delay
on, off
on, off
0-2147483647
0-2147483647
0-2147483647
0-2147483647
off, on
Valid IP address
a.b.c.d
on, off
off, on
Equivalent web parameter
Metric
Allow this PPP interface to settle for s
seconds after the connection has
come up
Enable "Always On" mode of this
interface, On, On and return to service
immediately
Put this interface "Out of Service"
when an always-on connection
attempt fails
remote disconnect
Attempt to reconnect after s seconds
If a PPP interface that would be
inhibited by this PPP is connected,
attempt to re-connect after s seconds
Wait s seconds after power-up before
activating this interface
Keep this interface up for at least s
seconds
Enable Multilink PPP on this interface
Add a route to a.b.c.d if the peer's IP
address is not negotiated
Enable DNS inbound blocking
Forward IP broadcasts over this
interface if this interface is on the same
IP network as an Ethernet interface
318