Digi TransPort WR31 User Manual page 260

Configure network interfaces
Stop data from being transmitted after n units
The total amount of data transmitted by this PPP instance before the link is blocked for further
traffic. The value in the drop-down list specifies the units: kilobytes, megabytes, or gigabytes.
Reset the data limit on the n day of the month
The day of the month on which the data limit is reset to 0.
Related CLI commands
Entity Instance Parameter
ppp n metric
ppp n aodion
ppp n immoos
ppp n aodi_dly
ppp n aodi_dly2
ppp n pwr_dly
ppp n tband
ppp n minup
ppp n maxup
ppp n maxuptime
ppp n timeout
ppp n timeout2
ppp n rxtimeout
ppp n maxneg
ppp n uplogmins
ppp n dlwarnkb
Digi TransPort WR Routers User Guide
Values Equivalent web parameter
0-255 Metric
0-2 Enable "Always On" mode of this interface, On, On
and return to service immediately
0=disabled
1=enabled
2=On and return
to service
immediately
on, off Put this interface "Out of Service" when an always-
on connection attempt fails
0-2147483647 Attempt to reconnect after s seconds
0-2147483647 If an inhibited PPP interface is connected, attempt
to re-connect after s seconds
0-2147483647 Wait s seconds after power-up before activating
this interface
0-4 Control when this interface can connect using Time
Band n
0-2147483647 Keep this interface up for at least s seconds
0-2147483647 Close this interface after s seconds
0-2147483647 if it has been up for m minutes in a day
0-2147483648 if the link has been idle for s seconds
0-2147483648 Alternative idle timer for static routes s seconds
0-2147483648 if the link has not received any packets for s
seconds
0-2147483648 if the negotiation is not complete in s seconds
0-2147483647 Generate an event after this interface has been up
for m mins
0-2147483647 Issue a warning after n units
Configure PSTN interfaces
260