Digi TransPort WR31 User Manual page 582

Configure legacy protocols
X.28 commands
Once an X.25 session layer has been established the router switches to PAD mode. In this mode,
operation of the PAD is controlled using the standard X.28 PAD commands listed in the following
table:
Command
CALL
CLR
ICLR
INPAR?
INPROF
INSET
INT
LOG
PAR?
PROF
RESET
RPAR?
RSET
SET
STAT
Digi TransPort WR Routers User Guide
Description
Make an X.25 call
Clear an X.25 call
Invitation to CLR
List X.3 parameters of specified PAD instance
Load or save specified PAD profile
Set X.3 parameters of specified PAD instance
Send Interrupt packet
Logoff and disconnect
List local X.3 parameters
Load or save PAD profile
Send reset packet
List remote X.3 parameters
Set remote X.3 parameters
Set local X.3 parameters
Display channel status
Configure X.25 parameters
582