Digi TransPort WR31 User Manual page 376

Configure IP routing and forwarding
Include this route in RIP advertisements
When enabled, the router includes this static route to be included in RIP advertisements.
Make PPP x interface use the alternative idle timeout when this route becomes available
When enabled, this check box, in conjunction with the PPP interface instance number in the text
box, cause the router to use the alternative inactivity timeout specified for that interface when
this route comes back into service. This feature is useful when it is preferable to close down a
backup route quickly when a primary route comes back into service.
Wait for s seconds after power up before allowing this route to activate the interface
The delay that the router should wait after power-up before packets matching this route will
initiate a connection of the interface configured in the route. W-WAN routers that have ISDN
backup typically use this setting to prevent unnecessary ISDN connections from being made
while a W-WAN connection is first being established.
If the interface is configured for "dial on demand"
Mark this route as "Out Of Service" if the interface fails to connect after n consecutive
attempts
Normally, if an interface is requested to connect by a route and fails to connect, the route metric
is set to 16 for the period of time specified by the Mark a static route as Out Of Service for s
seconds parameter on the Configuration > Network > IP Routing/Forwarding > IP Routing
page. If the value in this text box is non-zero, the route metric will not be set to 16 until the
number of connection attempts specified by this parameter have been made.
If the interface fails to connect, try again in s seconds
If an interface is requested to connect by this route (due to IP traffic being present) and it fails to
connect, the route will be marked as out of service but the router will continue to attempt to
connect at the interval specified by the value in this text box. If the interface does connect, the
router will clear the out of service status for the route.
Deactivate the interface after it successfully connects
When enabled, the router deactivates an interface once a successful activation attempt has
been made. The router uses this setting with the above retry parameter. If the above retry
parameter is not set, this setting is disabled.
Do not allow this interface to be activated by this route for s seconds after the last
activation attempt
The delay to wait before re-initiating a connection after it has dropped while still required.
Only queue one packet whilst waiting for the interface to connect
When enabled, the router enqueues only one packet while waiting for the interface to connect.
When unchecked, the router enqueues two packets.
Digi TransPort WR Routers User Guide
Default Route n parameters
376