Digi TransPort WR31 User Manual page 534

Configure legacy protocols
Related CLI commands
Entity Instance Parameter
snaip x l1iface
snaip x l1nb
snaip x protocol
snaip x ans
snaip x msn
snaip x sub
snaip x autocontact
snaip x dcd_toggle
snaip x l1oos
snaip x master
snaip x pollresp
snaip x stations
snaip x saps
snaip x dsaps
snaip x send_xid_null
snaip x xid_data
snaip x turntxtim
snaip x dtemode
snaip x n400
snaip x tnoact
Digi TransPort WR Routers User Guide
Configure Systems Network Architecture over IP (SNAIP)
Values
ISDN, Port,
SharedPort
0–255 (Select LAPB, Port
or SharePort instance)
LAPB, SNA, RAW,
RAW_NOHDR
1=enabled,
0=disabled
text
text
1=enabled,
0=disabled
1=enabled,
0=disabled
1=enabled,
0=disabled
1=enabled,
0=disabled
0-2147483647
text
text
text
1=enabled,
0=disabled
text
0-2147483647
1=DTE, 0=DCD
0-255
1000-60000
Equivalent web parameter
Send SNAIP traffic over interface.
Send SNAIP traffic over interface.
Use the specified protocol.
Allow this unit to answer calls.
Only accept calls with MSN ending with
the specified text.
Only accept calls with sub-address
ending with the specified text.
Assume station exists. (Do not send
TEST frames).
Toggle DCD output each time the DLSw
protocol enters the DISCONNECTED
state.
Sync port should not send or receive
data when WAN link is down.
Router to be Master on an unbalanced
link.
Polling Response Time.
Polling Stations Addresses.
SAPs.
DSAPs(blank=default).
Send Null XID (XID with no Data).
Send XID with Data.
Tx Turn Around Time.
Mode.
N400 counter.
RR Timer.
534