Digi TransPort WR31 User Manual page 580

Configure legacy protocols
Remote IP address
The IP address for outgoing XOT calls.
Use the source IP address from interface x,y
Which Ethernet or PPP interface to use for the source IP address.
Initiator interface
The name of the interface from which the PVC was initiated, such as Serial 1. The initiator and
responder strings identify the circuit when PVCs are being set up. They must match the names in
the remote router that terminates the XOT PVC connection. If the unit terminating the PVC XOT
connection is not another Digi router, you must refer to the documentation or the configuration
files of the other unit to determine the names of the interfaces.
Responder interface
The name of the interface to which a PVC initiator is connected, such as Serial 2.
Related CLI commands
Entity Instance Parameter
pvc n l2iface
pvc n lcn
pvc n uliface
pvc n psize
pvc n window
pvc n ipaddr
pvc n srcipent
pvc n srcipadd
pvc n iniface
pvc n respiface
Digi TransPort WR Routers User Guide
Values
Blank or lapb, lapd, tcp
0-4096
pad, tpad, xsw
0=default
4=16
5=32
6=64
7=128
8=256
9=512
10=1024
1-7
IP address
auto, eth, ppp
0-255
text
text
Configure X.25 parameters
Equivalent web parameter
Enable this PVC
LCN
Connect this PVC to PAD x
Use packet size
Use window size
Remote IP address
Use the source IP address from interface x,y
Use the source IP address from interface x,y
Initiator interface
Responder interface
580