Digi TransPort WR31 User Manual page 568

Hide thumbs Also See for TransPort WR31:
Table of Contents

Advertisement

Configure legacy protocols
IP Settings
Remote IP address
The destination host that will answer the XOT, TCP, SSL, or UDP call.
Remote IP Address when using the backup interface
The destination host that will answer the XOT, TCP, SSL, or UDP call if a connection via the
primary interface has failed and the PAD is configured to backup to a secondary interface that is
using an IP based protocol.
IP Stream port
The TCP or UDP port number to use for IP (but not XoT) connections.
IP length header
When set to On, and in IP Stream mode, the length of a data sequence is inserted before the
data. For the receive direction, it is assumed the length of the data is in the data stream. When
set to 8583 Ascii 4 byte, the IP length header conforms to the ISO 8583 format.
PAD Settings
PAD prompt
Allows you to redefine the standard PAD> prompt. To change the prompt, enter a new string of
up to 15 characters into the text box.
PAD mode
The PAD Mode parameter can be set to Normal or Prompt Always On. In Prompt Always On
mode, the ASY port attached to the PAD behaves as if it were permanently connected at layer 2,
such as it always displays a PAD> prompt. AT commands may still be entered but the normal
result codes are suppressed. To disable this mode set the parameter to Normal.
Use PAD Profile
The PAD profile # allows you to select the PAD profile to use for this PAD instance. There are four
pre-defined profiles, numbered 50, 51, 90, and 91. In addition to the pre-defined profiles, you
can also create up to four user-defined profiles numbered 1, 2, 3, and 4. To assign a particular
profile to the PAD select the appropriate number from the list.
Strip Trailing Spaces
If set to On, any spaces received at the end of a sequence of data from the network are removed
before being relayed to the PAD port.
Enable Leased Line Mode
If set to On, causes the PAD to always attempt to be connected using the Auto macro setting as
the call command.
Digi TransPort WR Routers User Guide
Configure X.25 parameters
568

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents