Digi TransPort WR31 User Manual page 679

Configure Remote Management
SNMP Trap Server parameters
Digi TransPort routers support two SNMP trap servers. The following options and description
explain how to configure a trap server.
Trap Server IP Address a.b.c.d
The IP address of the server running the SNMP software and determines the destination for the
trap notifications.
Port n
The UDP port number that the SNMP server is listening on, the default is 162, which is the
standard port number for this service.
Use SNMP Version
Select the required SNMP version number from this drop-down selection box.
Send "Inform Request" message
If you select SNMP version 2c or 3, the router can send a SNMP Inform Request message instead
of a Trap message. Inform Request messages are acknowledged by the SNMP Trap server
whereas Trap messages are not.
If no response, retransmit the Inform Request message after n seconds
The period after which the Inform Request message is retransmitted if no response has been
received.
Retransmit a maximum n times
The maximum number of times an Inform Request message is retransmitted. If no
acknowledgment is received after the maximum number of retransmissions, an event is logged.
Digi TransPort WR Routers User Guide
SNMP parameters
676