Digi TransPort WR31 User Manual page 157

Configure network interfaces
Entity Instance Parameter
eth n dmnr_reg
eth n nocfg
eth n mhome
eth n igmp
eth n bridge
eth n heartbeatip
eth n hrtbeatint
eth n hbipent
eth n hbipadd
eth n hbroute
eth n hbimsi
Digi TransPort WR Routers User Guide
Values Equivalent web parameter
on, off Enable DMNR advertisement from this subnet
0, 1, 2, 3 Remote management access
0=No restrictions
1=Disable management
2=Disable return RST
3=Disable management and return RST
0-255 Multihome additional consecutive addresses
0, 1 Enable IGMP on this interface
0, 1 Enable Bridge on this interface
IP address Send Heartbeat messages to IP address a.b.c.d
every h hrs m mins s seconds
0-86400 Send Heartbeat messages to IP address a.b.c.d
every h hrs m mins s seconds
This CLI value is entered in seconds only.
blank, eth, ppp Use interface x,y for the source IP address
x=Interface type
0-255 Use interface x,y for the source IP address
y=interface number
0, 1 Select the transmit interface using the routing
table
0, 1 Include IMSI information in the Heartbeat
message
Configure Ethernet interfaces
157