Digi TransPort WR31 User Manual page 365

Configure IP routing and forwarding
iBGP Routes
The CIDR metric that the router should use for iBGP routes. The default is 200.
Maximum static route metric
The maximum value for the routing metric. The default is 16.
Route directed IP broadcasts
When enabled, this setting causes the router to route directed broadcasts. The default state for
this parameter is Off. A directed broadcast is an IP packet with a destination address that is a
valid broadcast address for a subnet but does not originate from that subnet. A broadcast sent
from one interface to the subnet of another uses these directed IP broadcasts.
Wait s seconds before using an alternative route
The value in this text box specifies the latency to apply before passing traffic on an alternative
route in the current route becomes unavailable.
If an interface is configured for "dial on demand" and fails to connect,
Mark a static route as "Out Of Service" for s seconds
The value in this text box specifies the default time that a route should be marked as out of
service if the interface it uses fails to establish a connection.
When an "Always On" route becomes "In Service", wait s seconds before using it
The value in this text box specifies the delay that the router should apply to a route before
passing traffic on it once it has come into service.
Digi TransPort WR Routers User Guide
IP Routing parameters
365