Digi TransPort WR31 User Manual page 162

Configure network interfaces
Use interface x,y over which to send probe
Overrides the routing code and forces the probe packets to be sent out of a specific interface.
Get the source IP address from interface x,y
Enables probe packets having the source IP address from a specific interface, rather than the
interface over which it is being transmitted.
Related CLI commands
Entity Instance
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
eth n
Digi TransPort WR Routers User Guide
Parameter Values
vrrpid 0-255
vrrpprio 0-255
vboostprio 0-255
vboostsecs Integer
vprobemode off, TCP,
ICMP
vprobeip IP Address
vprobeport 0-65535
vprobebackint 0-32767
vprobemastint 0-32767
vprobeadj 0-255
vprobeadjup 0=down
1=up
vprobefailcnt 0-255
vprobesuccesscnt 0-255
vprobeent Auto, ETH,
PPP
vprobeadd Integer
vprobeipent Auto, ETH,
PPP
vprobeipadd Integer
Configure Ethernet interfaces
Equivalent web parameter
VRRP Group ID
VRRP Priority
Boost the priority by n for s seconds after
switching to the MASTER state
Boost the priority by n for s seconds after
switching to the MASTER state
Send p probe to IP address a.b.c.d TCP port n
Send p probe to IP address a.b.c.d TCP port n
Send p probe to IP address a.b.c.d TCP port n
every n seconds when in Backup state
every n seconds when in Master state
Adjust priority n dir after x probe failures
Adjust priority n dir after x probe failures
Adjust priority n dir after x probe failures
Reset probe failure count after n probe
successes
Use interface x,y over which to send probe
Use interface x,y over which to send probe
Get the source IP address from interface x,y
Get the source IP address from interface x,y
162