Digi TransPort WR31 User Manual page 306

Configure network interfaces
Entity Instance
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
ppp n
Digi TransPort WR Routers User Guide
Configure Advanced interfaces settings: External modems and PPP
Parameter Values
secDNS Valid IP address
DNSport Valid IP address
Default 53
IPmin Valid IP address
Default
10.10.10.10
IPrange 0-255
Default 5
transDNS Valid IP address
sectransDNS Valid IP address
cingnb up to 25 digits
msn up to 9 digits
sub up to 17 digits
cli
maxup 0-2147483648
maxuptime 0-2147483647
timeout Default 300s (5
minutes)
timeout2 0-2147483648
rxtimeout 0-2147483648
maxneg 0-2147483648
do_nat 0, 1
0=Off
1=On
natip Valid IP address
a.b.c.d
ipsec 0, 1
0=Off
1=On
Equivalent web parameter
Secondary DNS server
DNS Port
Assign remote IP addresses from a.b.c.d to
a.b.c.d
Assign remote IP addresses from a.b.c.d to
a.b.c.d Note that these are not directly
equivalent. This address is obtained by adding
the range value to the minimum.
Primary DNS server
Secondary DNS server
Only allow numbers ending with n
with ISDN MSN ending with n
with ISDN sub-address ending with n
Close the PPP connection after s seconds
if it has been up for m minutes in a day
if it has been idle for h, m, s
Alternative idle timer for static routes s seconds
if the link has not received any packets for s
seconds
if the negotiation is not complete in s seconds
Enable NAT on this interface
NAT Source IP address a.b.c.d
Enable IPsec on this interface
Keep Security Associations (SAs) when this PPP
interface is disconnected
306