Digi TransPort WR31 User Manual page 180

Configure network interfaces
Wi-Fi CLI commands
Entity Instance
wifinode 0
wifinode 0
wifinode 0
wifinode 0
wifinode o
eth n
eth n
eth n
wifinode 0
wifinode 0
wifinode n
wifinode n
How roam_threshold and roam_timeout parameters impact monitoring
If roam_threshold and roam_timeout are both non-zero, and the wifinode is configured in client
mode, monitoring of the signal strength of the link to the currently associated Access Point starts as
soon as the client has successfully connected to that Access Point. Monitoring of signal strength
stops at any time the client disconnects from the Access Point. If the RSSI of frames received from
the Access Point stays below the roam_threshold for roam_timeout consecutive seconds,
monitoring stops and the client starts scanning for Access Points.
Digi TransPort WR Routers User Guide
Parameter Values
enabled on, off
descr String
ssid String up to 32
characters
mode ap, client,
rogue
bridge_inst 0-3
bridge_inst 0-3
wificli on, off
wificli_add Integer
broadcastssid on, off
isolation on, off
roam_threshold RSSI value
roam_timeout Seconds
Configure Wi-Fi interfaces
Equivalent web parameter
Enable this Wi-Fi interface
Description
SSID
Mode
This Wi-Fi interface is a member of Bridge
instance n and therefore bridged to the following
interfaces
Interface
Link this Wi-Fi client interface with Ethernet n
Link this Wi-Fi client interface with Ethernet n
Hide SSID
Enable station isolation
None; command-line only
None; command-line only
180