Digi TransPort WR31 User Manual page 571

Configure legacy protocols
Entity Instance Parameter
pad n llmode
pad n enqcon
pad n stxmode
pad n delconmsg
pad n data_del
pad n inacttim
pad n nocalltim
pad n trig_str
pad n inactevent
Stopping and starting PADs
To stop and start PAD instances, use the following CLI commands:
stoppads: Stops all PAD instances from accepting and performing any PAD commands.
▪
gopads: Resumes processing of PAD commands.
▪
The stoppads and gopads commands can have the PAD number specified in the syntax to stop and
start individual PAD instances.
For example:
To stop PAD 1 from processing PAD commands:
▪
stoppads 1
To re-enable PAD 1:
▪
gopads 1
Digi TransPort WR Routers User Guide
Values
1=enabled
0=disabled
1=enabled
0=disabled
1=enabled
0=disabled
0-10
0-2147483647
0-1000
0-60000
text
0-2147483647
Configure X.25 parameters
Equivalent web parameter
Enable Leased Line Mode
Send ENQ on Connect
Enable STX / ETX Filtering
Delay connect message n x 10
milliseconds
Delay data transfer after connection by
n x 10 milliseconds
Terminate the PAD call after x seconds if
there has been no data transmission
Disconnect the layer 2 call if there is no
layer 3 call in progress for x seconds
Create an event when the following data
is on the PAD
Create an event when there has been no
activity on the PAD for x seconds
571