Digi TransPort WR31 User Manual page 156

Configure network interfaces
Related CLI commands
Entity Instance Parameter
n/a n/a ethvlan
n/a n/a ethhub
eth n group
eth n metric
eth n mtu
eth n auton
eth n speed
eth n duplex
eth n maxkbps
eth n maxtkbps
eth n tcptxbuf
eth n linkdeact
eth n do_nat
eth n ipsec
eth n ipsecent
eth n ipsecadd
eth n firewall
eth n block_dns
Digi TransPort WR Routers User Guide
Values Equivalent web parameter
n/a Switch to Port Isolate Mode
n/a Switch to Hub Mode
0-3,255 Ethernet Hub group
1-16 Metric
64-1500 MTU
0, 1 Enable auto-negotiation
0, 10, 100 Speed
0=Auto
10=10-BaseT
100=100-BaseT
0, 1, 2 Duplex
0=Auto
1=Full
2=Half
value in kbps Max Rx rate
value in kbps Max Tx rate
value in bytes TCP transmit buffer size
0-86400 Take this interface out of service after n seconds
when the link is lost
0, 1, 2 Enable NAT on this interface
0=Disabled
1=IP address
2=IP address and Port
0, 1 Enable IPsec on this interface
blank, eth, ppp Use interface x,y for the source IP address of
IPsec packets
x=Interface type
0-255 Use interface x,y for the source IP address of
IPsec packets
y=interface number
0, 1 Enable the firewall on this interface
on, off Enable DNS inbound blocking
Configure Ethernet interfaces
156