Installing A Cable On An Mx2020 Mpc Or Mic - Juniper MX2020 Hardware Manual

WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable manager, and detach it from the destination port.
SEE ALSO

Installing a Cable on an MX2020 MPC or MIC | 609

Installing a Cable on an MX2020 MPC or MIC
To install a MIC or an MPC cable (see
1. Have ready a length of the type of cable used by the component. For cable specifications, see the
Series Interface Module
2. If the cable connector port is covered by a rubber safety cap, remove the cap.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
3. Insert the cable connector into the cable connector port on the component faceplate.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when
Figure 264 on page 610
Reference.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when
and Figure 265 on page
609
610):
MX