MX480 3D Universal Edge Router Hardware Guide
Installing an MX480 Dual-Wide MIC
204
CAUTION:
Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Use one of the following methods to bring the MIC online:
11.
Press the MIC offline/online button until the MIC
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot mic-slot mic-slot online
For more information about the command, see the
Services Command Reference
The normal functioning status LED confirms that the MIC is online. You can also verify
correct MIC functioning by issuing the
in
"Maintaining MX480 MICs" on page
Figure 104: Installing a MIC
To install a dual-wide MIC (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the septum, if necessary (see
2.
Place the MPC on a flat surface (if necessary, remove the MPC from the router as
a.
described in
"Removing an MX480 MPC" on page
Remove the four screws labeled
b.
Remove the two screws labeled
c.
Slide the septum towards you and out of the MPC.
d.
Store the septum and screws for later use.
e.
Install the MPC as described in
f.
OK/FAIL
Junos OS System Basics and
.
show chassis fpc pic-status
129.
Figure 106 on page
206):
Figure 105 on page
196).
on the bottom of the MPC.
S
S
on the top of the MPC.
"Installing an MX480 MPC" on page
Copyright © 2011, Juniper Networks, Inc.
LED lights green.
command described
205):
198.