Table of Contents
Advertisement
Epson Research and Development
Vancouver Design Center
5.2 IT8368E Configuration
5.3 S1D13505 Configuration
Interfacing to the Philips MIPS PR31500/PR31700 Processor
Issue Date: 01/02/05
The ITE IT8368E has been specifically designed to support EPSON LCD/CRT controllers.
Older EPSON Controllers not supporting a direct interface to the Philips processor can
utilize the IT8368E MFIO pins to provide the necessary control signals, however when
using the S1D13505 this is not necessary as the Direct Connection described in Section 4,
"Direct Connection to the Philips PR31500/PR31700" on page 11 can be used.
The IT8368E must have both "Fix Attribute/IO" and "VGA" modes enabled. When both
these modes are enabled a 16M byte portion of the system PC Card attribute and IO space
is allocated to address the S1D13505.
When the IT8368E senses that the S1D13505 is being accessed, it does not propagate the
PC Card signals to its PC Card device. This makes S1D13505 accesses transparent to any
PC Card device connected to the same slot.
For mapping details, refer to Section 4.3, "Memory Mapping and Aliasing" on page 13. For
further information on configuring the IT8368E, refer to the IT8368E PC Card/GPIO
Buffer Chip Specification.
For S1D13505 configuration, refer to Section 4.2, "S1D13505 Configuration" on page 12.
Page 15
S1D13505
X23A-G-001-07
Advertisement
Chapters
Table of Contents
