Table of Contents
Advertisement
1 COMPOSITION OF
DEVELOPMENT SUPPORT TOOL
Here we will explain the composition of the software for the development support tools, develop-
mental envilonment and how to generate the execution disk.
1.1 Configuration of S5U1C60N08D
The below software are included in the product of the S1C60N08 development support tool S5U1C60N08D.
1. Cross Assembler ASM6008 .......................................... Cross assembler for program preparation
2. Function Option Generator FOG6008 ........................... Function option data preparation program
3. Segment Option Generator SOG6008 .......................... Segment option data preparation program
4. ICE Control Software ICS6008 ...................................... ICE control program
5. Mask Data Checker MDC6008 ...................................... Mask data preparation program
1.2 Developmental Environment
The software product of the development support tool S5U1C60N08D operates on the following host
systems:
• IBM PC/AT (at least PC-DOS Ver. 2.0)
When developing the S1C60N08, the above-mentioned host computer, editor, P-ROM writer, printer, etc.
must be prepared by the user in addition to the development tool which is normally supported by Seiko
Epson.
Host computer
(IBM PC/AT)
PC-DOS
Editor
• P-ROM writer
• Printer
Note The S5U1C60N08D system requires a host computer with a RAM capacity of about 140K bytes.
Since the ICE (S5U1C62000H) is connected to the host computer with a RS-232C serial interface,
adapter board for asynchronous communication will be required depending on the host computer
used.
S5U1C60N08D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C60N08)
S1C60N08 Development Tool
S5U1C62000A
ICE
RS-232C
S5U1C62000H
Fig. 1.2.1 System configuration
EPSON
1 COMPOSITION OF DEVELOPMENT SUPPORT TOOL
Software tools
S5U1C60N08D
ASM6008
ICS6008
FOG6008
MDC6008
SOG6008
Hardware tools
Evaluation Board
S5U1C60N08E
To be prepared by the user
Target board
1
Advertisement
Table of Contents
