General Information About Command And Setpoint Sources; Function Diagrams - Siemens SINAMICS S150 NEMA Operating Instructions Manual

Operation

6.2 General information about command and setpoint sources

6.2 General information about command and setpoint sources
Description
2 default settings are available for selecting the command sources and 4 for selecting the
setpoint sources for the SINAMICS S150 NA cabinet unit. The choice "No selection" is also
available; if selected, no default settings are applied for the command and setpoint sources.
Command sources
● PROFIdrive
● TM31 terminals
Setpoint sources
● PROFIdrive
● Analog inputs
● Motorized potentiometer
● Fixed setpoints
The various assignments are explained in the following sections.
Note
Defaults
Make sure that the default settings you choose during commissioning are compatible with
the drive configuration (see "Commissioning").
The EMERGENCY OFF signals (N57, N59, N60) are always active (regardless of the
command source).

Function diagrams

At certain points in this section, reference is made to function diagrams. These can be found
on the customer DVD in the "SINAMICS S120/S150 List Manual", which provides
experienced users with detailed descriptions of all the functions.
264
Operating Instructions, 12/2018, A5E36652151A
Enclosed Drives