4) Inspection of Cooling Water Passage
1.
Check cooling water intake for clog. Clean if necessary.
2.
Set lower unit in the water and start engine.
Check that cooling water check port 2 ejects water.
3.
6. Operating System
1) Adjustment of Throttle Cable
Loosen lock nut 1.
1.
Remove "R" shaped pin 2 and washer 3.
2.
Remove cable joint 4 from advancer arm 5.
3.
Bring advancer arm 5 to full close stopper 6.
4.
Set remote control lever to neutral (N) position 7.
5.
6.
Adjust cable joint screw-in length so that the pin of
advancer arm is aligned with the hole of cable joint 4.
Adjust cable joint screw-in length a to
10mm (0.39in) or over.
Adjust the cable joint so that advancer arm
pushes the full close stopper a little.
TLDI 75/90C2 2010
CAUTION
a
1
2
6
5
2
3
1
4
N
7
3
3-13