Service; Adding A Service To A Destination Device; Removing A Service - GE LOGIQ S7 Expert Service Manual

GE H RAFT
EALTHCARE
D 5460683, R
IRECTION EVISION
3-13-6

Service

For each Device that you added to the system, you need to set up the service(s) that device supports
(you must be an administrator to update these screens).
The Services screen has the following sections of information:
1.) Destination Device - lists information about destination devices. You can select from a list of
currently existing devices.
2.) Service Type to Add - lists information about services for the destination device. You can add
services, select from a list of currently existing services, and remove services.
3.) Service Parameters - lists parameters for the service currently selected in the Services section. The
name and parameters in this section change, depending on what service is currently selected. In
the above figure, this section shows DICOM Print parameters.
3-13-6-1

Adding a service to a destination device

1.) Select the service from the pull-down menu. Press Add.
2.) Specify the properties for this service. Press Save.
3.) Verify the service.
3-13-6-2

Removing a service

1.) Select the service. Press Remove.
2.) Press Save.
3-56
3 DRAFT (J
Figure 3-35 Connectivity Services Preset Menu, My Computer
Figure 3-36 Connectivity Services Preset Menu, New Device
Section 3-13 - Configuring Connectivity
25, 2014)
UNE
LOGIQ™ S7 E /P
XPERT RO
S M
ERVICE ANUAL