Table of Contents
Advertisement
October 2007
Communications
Parameters
Setting
Set the baud rate to be compatible with
Baud
the receiving device.
Node ID
Select Node ID number for PanaView
transmission
Test
Run test of RS-232 communications.
Service Options
System Information
Setting
ID
System Status
Software Versions
Locking the System Keys
4-12
Table 4-9: Communication Parameter Options
Description
IMPORTANT:
The Service menu is intended for factory-trained
personnel only, and access is limited by requiring a
service passcode. This menu allows the factory
default data, including calibration data and sensor
parameters, to be adjusted. Please contact an
applications or service engineer at GE Sensing if
access to these menus is required. Normal operation
of the OptiSonde does not require access to the
information contained in the Service menu.
Table 4-10: About Options
Description
Lists unit and sensor ID numbers.
Lists current uptime, last calibration date, last
balance date and time.
Lists current boot and program versions.
ENT
If you press
be locked, preventing access to the Main Menu. To unlock the keys,
ESC, ENT,
press
and
Available Options
1200, 2400, 4800, 9600, 19200, 38400,
57600, 115,200 (Note: 38400 is the default
value for PC communications.)
1 to 239 (Note: The default PanaView node ID
is 16.)
(After test, a check in lower right corner of
screen indicates correct operation; a short
message will be transmitted.)
(None)
(None)
(None)
LOCK
when
is highlighted, the OptiSonde keys will
ESC
ESC
. (Press
again to reenter the Main Menu.)
Available Options
Programming the OptiSonde
Advertisement
Table of Contents
