Konica Minolta cm-5 Instruction Manual page 5

Power Source
• Make sure that the power switch is set to OFF ("") when the CM-5 is not in use.
• This instrument can be powered from the AC adapter (AC-A305).
• Always use the AC adapter supplied as a standard accessory (AC-A305) and connect it to an AC outlet of the
rated voltage and frequency. Use an AC power supply of the rated supply voltage (within ±10%).
• Do not connect the AC adapter to an overloaded electrical circuit. In addition, do not wrap or cover the AC
adapter with cloth or other material while in use. Doing so may cause an electric shock or fire.
System
• Do not subject the CM-5 to strong impact or vibration.Doing so may cause deterioration in performance or a
breakdown.
• Since the specimen measuring port and integrating sphere are extremely precise optical components, great
care should be taken to prevent them getting dirty or exposing them to impact.
• The CM-5 may cause interference if used near a television, radio, etc.
• When the instrument is exposed to strong external static electricity, the LCD may go blank or the
measurement result may not be displayed properly. If the instrument is communicating with an external
device, the communication may be interrupted. In these cases, turn the power OFF and then turn it ON again.
If black smudges appear on the LCD, wait until they disappear naturally.
• When turning the power OFF and then ON again, wait several seconds after turning the power OFF.
Backup Battery
• Measured data and various settings are stored in the memory backed up by batteries. The backup batteries are
automatically charged during operation of this instrument, and can retain the contents of the memory for three
months if they have been fully charged. At the time of purchase, the backup battery may not be fully charged.
To charge the backup battery, set the power switch to ON. The backup battery is fully charged in 72 hours
while the instrument is switched on, and there is no danger of overcharging.
• It is recommended to keep a backup of your important data on another recording medium using the optional
Color Management Software SpectraMagic™ NX (CM-S100w).
• The backup batteries' model number is ML2020 (3 V).
Notes
• Do not try to replace the backup batteries by yourself. Contact a KONICA MINOLTA-authorized service
facility.
E3