Cleaning Parts - Konica Minolta cm-5 Instruction Manual

Cleaning Parts

This section explains how to clean the Target Mask, White Calibration Plate, Zero Calibration Box, and the
inside of the integrating sphere.
Target Mask and Transmittance Mask (Standard/optional accessory)
Use a blower to remove dirt and dust from the Target Masks.
Notes Do not touch the inside (edge) of the Target Mask with your
fingers. If it becomes dirty, wipe it with a soft, clean dry cloth.
White Calibration Plate (Optional)
• When the White Calibration Plate becomes dirty, gently wipe the
dirt off with a soft dry cloth. If the dirt is difficult to remove,
wipe it off with a cloth dampened with commercially available
lens cleaning solution. Then remove the solution with a cloth
dampened with water, and leave the plate to dry.
• When parts other than the White Calibration Plate become dirty,
lightly wipe the dirt off with a cloth dampened with water or
soapy water. Never use solvents such as thinner or benzene.
Be careful not to scratch the White Calibration Plate.
Notes
Zero Calibration Box (Optional)
Use a blower to remove dirt from the inside of the box.
If the inner surface is accidentally touched with hands or fingers,
wipe off the fingerprints or other traces gently with a soft dry cloth.
Edge
Edge
White Calibration Plate
Zero Calibration Box
CM-A124
1
E17