Pass/Fail Judgment For Color Difference; Pass/Fail Judgment Based On Tolerances - Konica Minolta cm-5 Instruction Manual

Pass/Fail Judgment for Color Difference

With the CM-5, you can set tolerances for the color difference of the sample data from the target color data to
make pass/fail judgment.
For the procedure of setting tolerances, refer to page 85 "Tolerance Setting" and page 89 "Default Tolerance
Setting".
The pass/fail judgment will be based on the target color data of the number selected for measurement, and on the
tolerance data specified for that target color data.
If target color data is deleted, neither the color difference display for the data nor the pass/fail judgment based on
the tolerances set to the data will be performed. Even if other target color data is selected, recalculations and
pass/fail judgments will not take place. If, however, another target color is assigned to the target color No. of the
deleted data, recalculations and pass/fail judgments will be performed.

Pass/Fail Judgment Based on Tolerances

If the measured color difference is outside the tolerances set for the target color, the value will be highlighted in
red to indicate that the judgment result is "Fail". Both + and - tolerances can be set for each target color.
To perform pass/fail judgment based on tolerances, follow the procedure given below.
Before using this function, you must set color difference tolerances.
Notes
[Operating Procedure]
1. Press the [TARGET/SAMPLE] button on the <Sample>
screen.
The <Target> screen is displayed.
• Every time the [Detail/List] button is pressed, the screen is
switched between the <Target> detail screen and
<Target> list screen.
2. Use the or
target color No.
In the list, you can press the
to change the screen entirely to the next screen.
The next step is to confirm the color difference tolerance
Memo
settings. If this confirmation is unnecessary, go to step 6.
E138
button of the cross key to select the
button of the cross key
or