Konica Minolta cm-5 Instruction Manual page 35

To save the condition file:
Verify that a USB memory device is
connected.
button of the cross key
Use the or
to move the cursor to
[OK/Edit] button.
After the condition file has been saved,
the <Meas. Cond. Settings completed>
screen appears.
20. Check that the cursor is on "Finish",
and press the [OK/Edit] button.
The Easy Setup Wizard is completed
and the <Sample> screen appears.
<Reflectance measurement using Petri Dish>
4. Use the or button of the cross
key to move the cursor to "Petri
Dish" and then press the [OK/Edit]
button.
The cursor moves to "Next".
5. Press the [OK/Edit] button.
6.
The <Measurement Area Selection>
screen appears.
Use the or button of the cross
key to move the cursor to the desired
measurement area and then press
the [OK/Edit] button.
The cursor moves to "Next".
7. Press the [OK/Edit] button.
and press the
2
E33