Performing Statistical Calculations On Sample Data - Konica Minolta cm-5 Instruction Manual

Performing Statistical Calculations on Sample Data

Performs statistical data on sample data stored in the instrument. The data to be used for calculations can be
selected in a list screen. After calculations have been performed, the average of the samples selected for
statistical calculations can be saved as a new sample data.
5. Use the or button of the cross key to select the
"Current" tab, use the
cursor to "Statistic calculation", and then press the
[OK/Edit] button.
6. The <Sample List> screen will appear.
7. Use the or button of the cross key to select a
sample to use for statistical calculations and then press
the [OK/Edit] button to confirm the selection.
• A check mark will appear in the box to the left of the
sample name when a sample is selected.
• Statistics can be performed using only samples measured
under the same measurement conditions (measurement
type, measurement area, SCI/SCE setting, linked target).
• To deselect a sample with a check mark, move the cursor to
the sample and then press the [OK/Edit] button again.
• To select all samples shown on the screen, use the
button of the cross key to move the cursor to the "Page"
button and then press the [OK/Edit] button. Check marks
will appear to the left of all samples shown.
• Use the button of the cross key to move to other
or
pages in instrument memory. Selected data will remain
selected even if pages are changed.
8. After all desired samples have been selected, use the
or button of the cross key to move the cursor to the
"OK" button and then press the [OK/Edit] button.
The <Statistic calculation> screen will appear.
• To save the average of the data as a new sample, use the
or button of the cross key to move the cursor to the
[Save] button and press the [OK/Edit] button. The new
data will be saved under the name "Averaged" and the
<Statistic calculation> screen will close.
• To exit the <Statistic calculation> screen without saving,
use the or button of the cross key to move the cursor
to the [Cancel] button and press the [OK/Edit] button.
The screen will return to the <Sample List> screen.
or button to move the
or
3
E125